
Quartz sand 1.0 – 3.0 mm
Quartz sand with a grain size of 1.0–3.0 mm, a coarser fraction for pool sand filters. Determine the quantity and arrangement of layers according to the filter manufacturer's instructions.
Variant1.0 – 3.0 mm
Description
Quartz sand with a grain size of 1.0–3.0 mm is a coarser fraction than 0.4–0.8 mm sand, which AstralPool specifies for filling its sand filters. The fractions, quantities and arrangement of layers depend on the version of the filter, so determine them according to its manufacturer's instructions.
Installation and maintenance
- Before filling, switch off the pump and set the valve to the closed position
- Fill the filter halfway with water, cover the diffuser and add the media up to the quantity stated on the filter's label
- After filling, backwash the filter for 3–5 minutes, then rinse for 30–60 seconds
Before ordering, check in the filter's datasheet whether it needs this fraction and in what quantity; call us for help.
Specifications
| Grain size | 1.0–3.0 mm |
|---|---|
| Material | quartz sand |
| Intended use | filter media for pool sand filters |
Need advice?
Call us with your pool's dimensions — we will tell you which filter, pump or heater fits, and what goes with it.
+385 95 377 6396Message us on WhatsAppRelated products
What customers buy with this.

Pool filters
Aster filter D500, 9 m³/h, 1½" side connection
5 variants

Pool filters
Galactic monobloc filter D380, 5 m³/h
2 variants

Pool pumps
Victoria Plus Silent VS 100, variable speed
2 variants
Advice
Read before you buy.
Pool pump: how to choose the right one (filter pump)
A pump is chosen by flow, not motor power: about 12 m³/h for 8 × 4 × 1.5 m – and the upper limit is set by the filter and the pipes.

Sand vs quartz pool filter – which one filters better
‘Sand’ and ‘quartz’ filters are the same thing; the real choice is quartz sand (30–60 µm) or activated glass (down to 5 µm).

Sand filter pump for a pool: sizing and installation
A monobloc of pump, filter and valve: flow (volume × 2) ÷ 8, how much sand goes into the D400–D750 and where the unit may be installed.

