
Quartz sand 0.4–0.8 mm
Quartz sand with a grain size of 0.4–0.8 mm, filter media for pool sand filters. AstralPool specifies this grain size for filling its Aster, Atlas and Galactic filters.
Variant0.4–0.8 mm
Description
Quartz sand with a grain size of 0.4–0.8 mm is filter media for pool sand filters. The sand grains retain dirt and fine suspended particles from the water passing through the filter. For filling its Aster, Atlas and Galactic filters, AstralPool specifies sand of this grain size, and the same filters can also be filled with active glass.
Installation and maintenance
- Before filling, switch off the pump and set the valve to the closed position
- Fill the filter halfway with water, cover the diffuser and add sand up to the quantity stated on the filter's label
- After filling, backwash the filter for 3–5 minutes, then rinse for 30–60 seconds
- It is recommended to replace the sand in the filter about every 3 years (AstralPool instructions)
Determine the required quantity of sand and the arrangement of layers from the label or datasheet of your filter; call us for advice.
Specifications
| Grain size | 0.4–0.8 mm |
|---|---|
| Material | quartz sand |
| Intended use | filter media for pool sand filters |
Need advice?
Call us with your pool's dimensions — we will tell you which filter, pump or heater fits, and what goes with it.
+385 95 377 6396Message us on WhatsAppRelated products
What customers buy with this.

Pool filters
Aster filter D500, 9 m³/h, 1½" side connection
5 variants

Pool filters
Galactic monobloc filter D380, 5 m³/h
2 variants

Pool pumps
Victoria Plus Silent VS 100, variable speed
2 variants
Advice
Read before you buy.
Sand filter pump for a pool: sizing and installation
A monobloc of pump, filter and valve: flow (volume × 2) ÷ 8, how much sand goes into the D400–D750 and where the unit may be installed.

Sand vs quartz pool filter – which one filters better
‘Sand’ and ‘quartz’ filters are the same thing; the real choice is quartz sand (30–60 µm) or activated glass (down to 5 µm).

Pool pump: how to choose the right one (filter pump)
A pump is chosen by flow, not motor power: about 12 m³/h for 8 × 4 × 1.5 m – and the upper limit is set by the filter and the pipes.

