
SPA Pipework cleaner
AstralPool SPA Collection pipework cleaner (1 l): liquid degreaser that removes biofilm and grease from hydromassage tub pipes, non-foaming.
Description
SPA Pipework Cleaner is a liquid degreaser from the SPA Collection range, formulated to remove the biofilm that builds up in hydromassage tub pipes. It cleans and degreases dirt deposited in the pipes and removes scale deposits that the dirt forms in them. It does not foam. The pack size is 1 l.
Advantages
- Removes biofilm and degreases the tub's pipes
- Removes scale deposits caused by dirt in the pipes
- Non-foaming
- Recommended cleaning frequency: about 3–4 times a year
Installation and maintenance
- Fill the tub with water 5–10 cm above the jets (the existing water can be used) and remove the filter cartridges
- Add half a bottle (500 ml) for tubs of 1,000 to 3,000 l
- Run the filtration and massage pumps for about 30 minutes
- Empty the tub, fill it with clean water, run both pumps for 1–2 minutes to rinse, and empty it again
- Put back a new or cleaned cartridge and fill the tub with clean water with disinfectant (chlorine or bromine)
- Bathing is not allowed during cleaning
What this product does
The cleaner removes grease, scale and deposits from the part named in the product title (waterline, filter, pipework or surfaces). Rinse that part thoroughly with clean water after cleaning.
Work out the amount and method of dosing from the instructions on the label and the volume of water in your pool or hot tub.
Safety and labelling
Hazard labelling from the label
Danger
- H314 Causes severe skin burns and eye damage.
We send the safety data sheet on request
Keep out of the reach of children, in the original closed packaging, in a dry and cool place. Do not mix different products or add them at the same time. Always add the product to water, never water to the product.
Specifications
| Pack size | 1 l |
|---|---|
| Form | liquid, colourless |
| Dosage | 500 ml (half a bottle) for tubs of 1,000 to 3,000 l |
| Treatment time | about 30 minutes of pump running |
| Cleaning frequency | about 3–4 times a year |
| Density | 0.90–0.98 g/cm³ |
| pH | 10–11 |
Documents
Need advice?
Call us with your pool's dimensions — we will tell you which filter, pump or heater fits, and what goes with it.
+385 95 377 6396Message us on WhatsAppRelated products
What customers buy with this.
Advice
Read before you buy.
Robotic pool cleaner or pool vacuum: which to choose
A robot if you want the pool to clean itself, a battery vacuum if you clean now and then – in our range, from €335 to €2,200.

Pool pump: how to choose the right one (filter pump)
A pump is chosen by flow, not motor power: about 12 m³/h for 8 × 4 × 1.5 m – and the upper limit is set by the filter and the pipes.

Sand filter pump for a pool: sizing and installation
A monobloc of pump, filter and valve: flow (volume × 2) ÷ 8, how much sand goes into the D400–D750 and where the unit may be installed.





