
Cantabric pressure gauge kit
Pressure gauge installation set for the AstralPool Cantabric filter. The gauge monitors the pressure in the filter; when the pressure rises by 0.5 kg/cm² above the initial pressure, the filter needs to be backwashed.
Description
The pressure gauge set is intended for AstralPool Cantabric filters, which are equipped with a pressure gauge and manual air and water drains. The gauge shows the pressure in the filter and thereby the saturation of the filter media.
Installation and maintenance
- According to the Cantabric filter manual, the pressure gauge is connected to the filter via a T-piece with a seal and an air bleed plug
- Tighten the T-piece by hand, without tools and without PTFE tape
- The pressure is read in kg/cm² and PSI; in the example from the manual, the initial pressure is 0.8 kg/cm² (11.4 PSI), and the filter needs to be backwashed when the pressure rises by 0.5 kg/cm², to 1.3 kg/cm² (18.5 PSI)
- Backwashing takes 2 minutes and rinsing 1 minute; the first backwash after filling the filter takes 4 minutes
Before ordering, check that the set fits your Cantabric filter; we are happy to help you choose.
Specifications
| Intended use | pressure gauge for the AstralPool Cantabric filter |
|---|
Documents
Need advice?
Call us with your pool's dimensions — we will tell you which filter, pump or heater fits, and what goes with it.
+385 95 377 6396Message us on WhatsAppRelated products
What customers buy with this.

Pool filters
Aster filter D500, 9 m³/h, 1½" side connection
5 variants

Pool filters
Galactic monobloc filter D380, 5 m³/h
2 variants
Advice
Read before you buy.
Pool pump: how to choose the right one (filter pump)
A pump is chosen by flow, not motor power: about 12 m³/h for 8 × 4 × 1.5 m – and the upper limit is set by the filter and the pipes.

Sand vs quartz pool filter – which one filters better
‘Sand’ and ‘quartz’ filters are the same thing; the real choice is quartz sand (30–60 µm) or activated glass (down to 5 µm).

Sand filter pump for a pool: sizing and installation
A monobloc of pump, filter and valve: flow (volume × 2) ÷ 8, how much sand goes into the D400–D750 and where the unit may be installed.



