
Aster pressure gauge kit
Pressure gauge installation set for the AstralPool Aster filter. The gauge monitors the pressure in the filter, and a rise in pressure warns that the filter needs to be backwashed.
Description
The pressure gauge set is intended for AstralPool Aster filters, which are equipped with a pressure gauge for monitoring the pressure in the filter. The gauge shows the degree of saturation of the filter media: when the pressure rises, the filter needs to be backwashed.
Installation and maintenance
- According to AstralPool's instructions for filters with a multiport valve, the pressure gauge assembly consists of a T-piece, a seal, the pressure gauge and an air bleed
- Tighten the T-piece by hand, without tools; PTFE tape is not needed because the seal ensures watertightness
- Example from the instructions: the normal pressure at the start of the filtration cycle is 0.8 kg/cm², and at 1.3 kg/cm² the filter needs to be backwashed
- Check the pressure at least once a week and replace a faulty pressure gauge
Before ordering, check that the set fits your Aster filter; we are happy to help you choose.
Specifications
| Intended use | pressure gauge for the AstralPool Aster filter |
|---|
Documents
Need advice?
Call us with your pool's dimensions — we will tell you which filter, pump or heater fits, and what goes with it.
+385 95 377 6396Message us on WhatsAppRelated products
What customers buy with this.

Pool filters
Aster filter D500, 9 m³/h, 1½" side connection
5 variants

Pool filters
Galactic monobloc filter D380, 5 m³/h
2 variants
Advice
Read before you buy.
Pool pump: how to choose the right one (filter pump)
A pump is chosen by flow, not motor power: about 12 m³/h for 8 × 4 × 1.5 m – and the upper limit is set by the filter and the pipes.

Sand vs quartz pool filter – which one filters better
‘Sand’ and ‘quartz’ filters are the same thing; the real choice is quartz sand (30–60 µm) or activated glass (down to 5 µm).

Sand filter pump for a pool: sizing and installation
A monobloc of pump, filter and valve: flow (volume × 2) ÷ 8, how much sand goes into the D400–D750 and where the unit may be installed.



