
Activated glass 1.0 mm – 3.0 mm
Active Clear Glass (AstralPool), active glass with a grain size of 1.0–3.0 mm, made from 100% recycled glass. A direct replacement for quartz sand in pool sand filters.
Variant1.0 mm – 3.0 mm
Description
Active Clear Glass is filter media made from 100% recycled glass that directly replaces quartz sand in pool sand filters. The 1.0–3.0 mm fraction (grade 2, medium) has an effective grain size d10 of 1.1 mm and makes up 20% of the recommended filter media composition for filters with a diameter above 90 cm. For Active Clear Glass, the manufacturer states a turbidity removal efficiency of 95% according to EN 16713-1.
Advantages
- Bulk density of 1,310 kg/m³ is about 15% lower than that of sand, so 15% less media by weight is needed
- Recommended filtration rate below 50 m³/h/m²
- Backwash at a rate of 40–50 m³/h/m², usually for 5–10 minutes or until the water runs clear
- Recycled glass that can be disposed of in a glass recycling container
Installation and maintenance
- Fill the filter halfway with water, then spread the glass evenly
- Leave at least 30% of the filter height free above the media so the bed can expand during backwash
- Initial backwash: at least 3 consecutive backwashes with clean water, 10–15 minutes each, then rinse for at least 1 hour
- For filters with a diameter below 90 cm, the manufacturer recommends 80% of the 0.5–1.0 mm fraction and 20% of the 3.0–7.0 mm fraction; for filters above 90 cm, 60% of the 0.5–1.0 mm fraction, 20% of the 1.0–3.0 mm fraction and 20% of the 3.0–7.0 mm fraction
Check the exact composition and quantity of media for your filter in its datasheet, or call us.
Specifications
| Grain size | 1.0–3.0 mm (grade 2, medium) |
|---|---|
| Effective grain size (d10) | 1.1 mm |
| Uniformity coefficient (d60/d10) | 1.7–1.9 |
| Bulk density | 1,310 kg/m³ |
| Specific density | 2,500 kg/m³ |
| Material | 100% recycled glass |
| Filtration rate | below 50 m³/h/m² |
| Backwash rate | 40–50 m³/h/m² |
| Pack size | 25 kg bag |
| Turbidity removal efficiency | 95% (EN 16713-1, section 7.2) |
Documents
Need advice?
Call us with your pool's dimensions — we will tell you which filter, pump or heater fits, and what goes with it.
+385 95 377 6396Message us on WhatsAppRelated products
What customers buy with this.

Pool filters
Aster filter D500, 9 m³/h, 1½" side connection
5 variants

Pool filters
Galactic monobloc filter D380, 5 m³/h
2 variants
Advice
Read before you buy.
Pool pump: how to choose the right one (filter pump)
A pump is chosen by flow, not motor power: about 12 m³/h for 8 × 4 × 1.5 m – and the upper limit is set by the filter and the pipes.

Sand vs quartz pool filter – which one filters better
‘Sand’ and ‘quartz’ filters are the same thing; the real choice is quartz sand (30–60 µm) or activated glass (down to 5 µm).

Sand filter pump for a pool: sizing and installation
A monobloc of pump, filter and valve: flow (volume × 2) ÷ 8, how much sand goes into the D400–D750 and where the unit may be installed.


