
SPA Clarifier
AstralPool SPA Collection clarifier (1 l): liquid polymer flocculant that removes the finest particles from hydromassage tub water, which filtration cannot retain.
Description
SPA Clarifier is a liquid polymer flocculant from AstralPool's SPA Collection range. It removes the finest particles in hydromassage tub water, which the filtration equipment cannot retain because of their size, and prevents the water from becoming cloudy. The pack size is 1 l.
Advantages
- Clarifies the water and acts quickly (manufacturer's data)
- Removes particles that filtration does not retain
- Corrective treatment: 10 ml per 1 m³ of water (1 cap = 15 ml)
- Maintenance: 15 ml per 1 m³ of circulating water, with a dosing pump upstream of the filter
Installation and maintenance
- Switch off filtration and make sure there are no bathers in the tub
- Dilute the measured dose in a container of water and distribute it evenly over the water surface
- After 8 hours, remove the flakes that have settled on the bottom with a pool vacuum cleaner
- The doses are guidelines and can be adjusted to the individual tub and conditions
What this product does
A flocculant (clarifier) binds fine particles that the filter cannot hold into larger clumps, which the filter then catches or which settle on the floor to be vacuumed. Use it when the water is cloudy despite good disinfection and the right pH.
Work out the amount and method of dosing from the instructions on the label and the volume of water in your pool or hot tub.
Safety and labelling
Hazard labelling from the label
Warning
- H290 May be corrosive to metals.
- H319 Causes serious eye irritation.
We send the safety data sheet on request
Keep out of the reach of children, in the original closed packaging, in a dry and cool place. Do not mix different products or add them at the same time. Always add the product to water, never water to the product.
Specifications
| Pack size | 1 l |
|---|---|
| Form | liquid, colourless |
| Active substance | polymer flocculant |
| Dosage (corrective) | 10 ml per 1 m³ of water (1 cap = 15 ml) |
| Dosage (maintenance) | 15 ml per 1 m³ of circulating water, upstream of the filter |
| Density | 1.16–1.26 g/cm³ |
| pH (1% solution) | 3.5–4.5 |
Documents
Need advice?
Call us with your pool's dimensions — we will tell you which filter, pump or heater fits, and what goes with it.
+385 95 377 6396Message us on WhatsAppRelated products
What customers buy with this.

Spa chemicals and accessories
SPA collection 6-in-1 test strips
Advice
Read before you buy.
Robotic pool cleaner or pool vacuum: which to choose
A robot if you want the pool to clean itself, a battery vacuum if you clean now and then – in our range, from €335 to €2,200.

Pool pump: how to choose the right one (filter pump)
A pump is chosen by flow, not motor power: about 12 m³/h for 8 × 4 × 1.5 m – and the upper limit is set by the filter and the pipes.

Sand filter pump for a pool: sizing and installation
A monobloc of pump, filter and valve: flow (volume × 2) ÷ 8, how much sand goes into the D400–D750 and where the unit may be installed.




